Monday, January 31, 2011


Then the last tube. I dont use a pipebender I only use an accetylen oxygen torch for bending the pipes for this work. After this start welding. Remeber when fiting the tubes on the frame dont use any force to keep then in place or you will fu*k up the frame when you take it out of the frame jig.
Then center and level the second cast part to the first one. Then fit in the second back down tube. Then the top tubes just tac the tubes no coplete welding yet.

Started on the right down tube because it is in line with the rest of the frame tubes.

Closeup of the weld and how the cast part is cleaned befor the backtubes are welded in place.

The neck is centered in the jig and on the frame, and ready for welding.

No comments:

Post a Comment